DCC Point Controllers
Easy to set up and use One Touch DCC Point Controllers
These DCC modules enables you to quickly and easily control most popular 2-position 12-16V point motors, eg Peco, Hornby etc
Some semaphore signals and uncouplers can also be controlled by point motors.
Like all of our DCC modules it takes all of its power from the standard 2 wire DCC track or controller output and it has a built in CDU which helps give the point motor a good boost of power without draining too much from the DCC supply all at once.
The point motor is simply connected to the control module.
One-Touch DCC™ is our way of instantly controlling your new signals or accessories - NO programming CV codes etc.
• Control points and uncouplers using DCC
• Easy One Touch DCC - No CV Programming!
• Just connect 2 wires to nearly DCC rails
• Easy screw terminals - no soldering
• Use standard solenoid point motors
• Built in powerful CDU for efficient operation
Easy to fit: Screw terminals connect just 3 wires to any standard point motor (e.g. Peace, Hornby etc) and 2 wires to the nearest DCC rails or bus.
Easy to use: Choose an accessory address, press the One Touch button then send an accessory command from your DCC controllers or PC.
Thats it, you are ready to go!
Synchronise Points and Signals easily: As well as controlling each point individually you can easily synchronise to otherSignals and Points by using
the same DCC accessory address for everything you want to sync, so that routes can be set with correct signalling using a single command!
PC1 Single DCC Point Controller
(Motor housing and track not included)
Single Point Controller - Controls 1 point
PC1 Single Point Controller 
Click the PDF icon to download the user manual 
PC2 Quad DCC Point Controller
Quad Point Controller - Controls 4 point
PC2 Quad Point Controller
Click the PDF icon to download the user manual
PC200 Quad DCC Point Controller with Multiple Route Store & Switch Control
Like the PC2, this module includes a built-in CDU and controls 4 solenoid point motors by DCC, setting up instantly using One Touch DCC.
Manual Control
In addition to control by DCC, the PC200 also has 4 switch inputs for manually controlling each of the 4 points. You can either use regular switches such as toggles, or you can also connect the new Mimic Switch to both control and display the Points position on your own control panel - see Mimic Switches and Lights.
Route Store
As well as the 4 main DCC addresses, the PC200 can also save multiple routes; By setting an extra address you can control groups of points using a single command, allowing easy setting of routes.
PC200 Quad Point Controller with Route Store & Switch Control
Click the PDF icon to download the user manual
Compatible with Railmaster